Champion Power Equipment 100166 Instruction Manual download pdf (Page 15)

100166 ENGLISH

OPERATION

Connecting the Outlet Hose

1. Slide the pipe joint (A) over the 90º outlet joint (B)

and then place the rubber gasket (C) into the base

of the pipe joint.

4. Prime the pump. (E) See priming the pump section>

2. Connect the outlet hose to the 90º outlet joint with

a hose clamp. (D)

3. Tighten the screw on the hose clamp to secure. Do not

overtighten.

The once connected to the pump, there may be

some threading left after hand tightening. This is

normal. DO NOT overtighten the pipe joint with any

wrench, tool, or otherwise.

NOTE

Telfon tape or other sealers are not needed for a

water tight connection. The rubber gasket should

help to make the connection more water tight.

NOTE

Both the intake and outlet ports are

1 in. (2.5 cm). Please insure the connectors to

the suction and discharge hose are 1 in. (2.5 cm)

threaded.

NOTE

Connecting the Outlet Hose Cont’d.

5. Connect the 90º outlet joint to the pump. (G)

6. Hand tighten the joint to the pump. Do not over

tighten.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

No comments

Champion Power Equipment 100166 Instruction Manual Page 15