Champion Power Equipment 41135 Owner's Manual download pdf (Page 11)

REV 41135-20110701 8

41135 ENGLISH

ASSEMBLY

Your generator requires some assembly. This unit ships

from our factory without oil. It must be properly serviced

with fuel and oil before operation.

If you have any questions regarding the assembly of your

generator, call our help line at 1-877-338-0999. Please

have your serial number and model number available.

Remove the Generator from the Shipping Carton

1. Set the shipping carton on a solid, ﬂat surface.

2. Remove everything from the carton except the

generator.

3. Carefully cut each corner of the box from top to

bottom. Fold each side ﬂat on the ground to provide a

surface area to install the wheel kit and support leg.

Install the Wheel Kit

You will need the following tools to install the wheels:

• 17 mm wrench OR adjustable wrench (not included)

• Socket wrench with a 16 mm socket (not included)

• Pliers (not included)

1. Before adding fuel and oil, tip the generator on it’s side.

2. Slide the M10x105 wheel bolt through the washer,

sleeve and wheel.

3. Slide the bolt through the mount point on the frame.

4. Fasten securely with the M10 nut.

5. Repeat steps 2-4 to attach the second wheel.

Install the Support Leg

1. Attach the support leg to the generator frame with

cap screws (M8x16) and nuts (M8).

2. Tip the generator slowly so that it rests on the

wheels and support leg.

The wheel kit is not intended for over-the-road use.

CAUTION

1. Place the generator on a ﬂat, level surface.

Add Engine Oil

DO NOT attempt to crank or start the engine before

it has been properly ﬁlled with the recommended

type and amount of oil. Damage to the generator as

a result of failure to follow these instructions will

void your warranty.

CAUTION

Install the Handles

1. Place the handle over the mounting channel on the

frame.

2. Secure the handle to the frame using the two handle

bolts (M8x45).

3. Place a lock nut (M8) on the end of each bolt and

fasten securely. DO NOT over tighten the lock nuts.

The recommended oil type is 10W-30 4-cycle automotive oil.

NOTE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments

Champion Power Equipment 41135 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Power generators Champion Power Equipment 41135